General Trueing

Troubleshooting

• Robot SG (DB): One hand truing not available anymore
• Wheel stop of incoming rail not opening
• Robot OT (DE): Screwdriver is moving in and out continuously
• Rim Drive not turning in Automatic Mode
• Wheel not between hub clamps
• Robot DC/DD/DTI: The rim driver and nipple keys opening and closing.
• Robot DC: The nipple arms move forward and backward on the same set of spokes
• The wheel comes in, but the wheel stop doesn't stop the next wheel.
• Robot DC: Message air pressure to low.
• Robot DTI (DT): Testing stepping motors
• Robot DC: Machine doesn't turn the wheel ( Automatic mode)
• Robot OT (DE): Screwdriver position not correct on nipple

See less ▼

Adjustments

• Robot DC/DD: Hub clamp height adjustment
• Robot SG (DB): How to setup a wheel
• Adjust upper guide rails
• Adjust diameter measuring unit (DMU)
• Wheel stopper alignment
• Robot DC: How to adjust spoke sensor
• Robot DC/DD: Nipple Keys on Nipples
• Robot DC/DD/DTI: Zero position of nipple hand
• Robot DC/DD/DTI: Adjusting Spoke Sensors
• Robot DC/DD/DTI: Adjusting pattern recognition
• Robot DTI (DT): Nipple hand depth adjustment
• Calibrate nipple motors
• Hub Clamps sensor adjustment
• Robot DTI (DT): Motor axial angle left home position
• Robot SG (DB): Set zero position for nipple keys
• Robot DC: Calibrate nipple motors
• Robot DTI (DT): Test Nipple Motors
• Robot SG (DB): Check if nipplehands have correct torque.
• Robot DTI (DT): Calibration Nipple motor
• Robot DC: Nipple Hand Angle
• Robot DC/DTI: How to set zero position nipple key
• Robot DTI (DT): Adjust pitch nipple hands (manual)
• How to calibrate machine center
• Robot DC/DD/DTI: Radial angle nipple hands
• Robot DC/DD: Adjust axial position nipple hand
• Robot DTI (DT): Motor axial angle right home position
• Robot DC/DD/DTI: Correct position of the height position
• Robot DTI (DT): Adjust height nipple hands
• Robot DTI (DT): Adjust pitch nipple hands (auto pitch)
• Adjusting Spoke Sensors

See less ▼