General Lacing

setup

• Lacing Machine - Long or short spokes appearing during lacing.

Troubleshooting

• Thermal protection screwdriver motor active
• Lacing: Machine loses settings/options
• Lacing: Machine stops during use and returns to the home screen.
• CS: Screwdriver is not going forward after activating spoke guide sensor
• Machine is starting but message on screen stays at "Press green start button"
• Nippleguide bad/Nipples fall off the screwdriver
• The machine does not adjust itself to start working in function Lacing (1= lacing)
• Machine does not detect holes
• The nipples are not coming out of the nipple block
• The machine is turning counterclockwise or rotating slowly during the lacing process.
• Screwdriver pauses after each hole
• Sudden change of tightness.

See less ▼

Adjustments

• Easy Cam Lacer (CE): Changing the nipple guide spring
• How to adjust and test nipple container(s)
• Adjustment of the screwdriver.
• Screen explanation during lacing
• How to check +5V
• Adjusting hub support
• Inline Lacer (CN): Motor Tilt Adjustment
• Adjusting the needle pulse sensor
• Adjust spoke guide unit
• Machine pushing the rim out of the work area.
• Adjusting screwdriver length and center
• Easy Cam and Intelligent Single Lacer (CS/CD): Adjust eject nipple unit
• Easy Cam Lacer (CE): How to replace the index motor belts

See less ▼